Microcom 428T Bedienungsanleitung PDF herunterladen (Seite 225)

428T Operator’s Manual - 880037-0141 13-5

Appendix C: ^D Command Summary

5 NULLS + 01: The 5 NULL method commands are a way to pass commands to the

printer even when the printer in configured in binary compression mode.

The command is sent to the printer as HEX characters; 00 00 00 00 00

01 are sent to the printer in order to issue the command. This command

is used to request the printer’s status and is very similar to the ^E

command. The biggest difference between this command and the ^E is

that when printers are configured for binary compression (D23 -SW3 bit

7), which is required if saving graphics, the ^E will not function. This

means that if the printer is going to be using binary compression, the 5

NULL’s method should be used to request status instead of the ^E

command.

5 NULLS + 02: The 5 NULL method commands are a way to pass commands to the

printer even when the printer in configured in binary compression mode.

The command is sent to the printer as HEX characters; 00 00 00 00 00

02 are sent to the printer in order to issue the command. This command

is used to cancel pending jobs/commands and to remotely clear errors

returning the printer to an idle >READY< state. If the condition causing

the original error condition still exists, sending new jobs will cause the

printer to go back into an error condition. This command simply

provides the ability to remotely clear error conditions and return the

printer to a state that allows normal communication.

5 NULLS + 04: This command is sent to the printer as HEX characters; 00 00 00 00 00

04 to clear the >TAKE LABEL< condition. The >TAKE LABEL< status

message is issued when the printer is being used with a ^D97 or ^D98

dispense mode and LTS sensor is detecting media. The

communication channel is disabled until the media is taken under

normal circumstances so this command is provided to bypass the

communication and clear the status. After issuing this command, the

media will retract the ^D95 distance and the printers normal

communication will return.

5 NULLS + 0F: The 5 NULL method commands are a way to pass commands to the

printer even when the printer in configured in binary compression mode.

The command is sent to the printer as HEX characters; 00 00 00 00 00

0F are sent to the printer in order to issue the command. This command

instructs the printer to exit the temporary binary mode switch. If a

printer has been configured to use binary compression mode using the

soft switch command (D23 - SW3 bit 7), the NULL’s + 0F method will

be ignored when issued.

0F + 5 NULLS: The 5 NULL method commands are a way to pass commands to the

printer even when the printer in configured in binary compression mode.

The command is sent to the printer as HEX characters; 0F 00 00 00 00

00 are sent to the printer in order to issue the command. This command

1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 248 249

Kommentare zu diesen Handbüchern

Keine Kommentare

Microcom 428T Bedienungsanleitung Seite 225

Kommentare zu diesen Handbüchern

Vaillant Acondicionadores de aire del sistema de división manuales de usuario

Microcom 428T Bedienungsanleitung Seite 225

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Drucker Microcom 428T

Vaillant Acondicionadores de aire del sistema de división manuales de usuario